|
|
Post by scanny on Aug 24, 2021 14:43:14 GMT
I wonder what metal they are made of? Could they damage rifling if using them on regular basis?
|
|
CaptDAR
Moderator
The RIF Marshall
Always count your shots and don’t miss
Posts: 4,844
Likes: 5,900
|
Post by CaptDAR on Aug 24, 2021 14:48:04 GMT
Apparently and alloy of tin and zinc. Should be ok in a smooth bore but possibly? Over a very lengthy time might? Damage rifling.
|
|
|
Post by HeadHunter on Aug 24, 2021 15:48:39 GMT
I would definitely advocate only using these in a smoothbore barrel as their hardness could prematurely wear the rifling.
It's horses for courses, if you was looking for hunting pellet with good penetration on game then these are definitely on the list but for the typical CO2 handgun plinking in the back garden or (worse still) indoors I think that these are unsuitable in terms of accuracy, cost and ricochets (unless used on a 'soft' box type of target).
I tried some light weight alloy pellets a good while back and found them to be totally useless for my needs (as a CO2 recreational plinker), I could only use them in my Schofield, Remington 1875 and a couple of my Colt SAAs and found the accuracy very poor indeed. Cheaper lead pellets are far more accurate than they were in the same guns, which was a shame as I was hoping for some improvement for the extra cost of the alloy pellets ! But you've got to try these things out.
A great review David, some very useful information and I'm sure that it'll be of benefit to a lot of our members when they contemplate going down the 'alternative' pellet route.
|
|
Doyley83
Bounty Hunter
Helpful member and Share holder.
Posts: 3,417
Likes: 4,133
|
Post by Doyley83 on Aug 24, 2021 17:40:32 GMT
Great overview David, might give these a swerve as main preference of pellets with my replicas is to fully avoid ricochets at short indoor range
|
|
CaptDAR
Moderator
The RIF Marshall
Always count your shots and don’t miss
Posts: 4,844
Likes: 5,900
|
Post by CaptDAR on Aug 24, 2021 17:45:22 GMT
Great overview David, might give these a swerve as main preference of pellets with my replicas is to fully avoid ricochets at short indoor range Yes I had to put my ballistic glasses on to complete the metal plate shooting part. Mind, they are amazing can destroyers.
|
|
|
Post by HeadHunter on Aug 24, 2021 19:02:10 GMT
Great overview David, might give these a swerve as main preference of pellets with my replicas is to fully avoid ricochets at short indoor range Yes I had to put my ballistic glasses on to complete the metal plate shooting part. Mind, they are amazing can destroyers. They seem to have the weight and the hardness to 'destroy' quite a few things, they do have their usefulness. Especially if you're looking to obliterate an object then they would probably be a great choice.
|
|
Doyley83
Bounty Hunter
Helpful member and Share holder.
Posts: 3,417
Likes: 4,133
|
Post by Doyley83 on Aug 24, 2021 19:46:29 GMT
Would like to see how these perform in a full power rifle (UK legal and sorry for the non replica context)
|
|
|
Post by HeadHunter on Aug 24, 2021 20:16:59 GMT
Would like to see how these perform in a full power rifle (UK legal and sorry for the non replica context) I think that is where they are really intended to be used....
|
|
CaptDAR
Moderator
The RIF Marshall
Always count your shots and don’t miss
Posts: 4,844
Likes: 5,900
|
Post by CaptDAR on Aug 24, 2021 20:43:02 GMT
Would like to see how these perform in a full power rifle (UK legal and sorry for the non replica context) I’m going to try a few of them through my MFR and Winnie.
|
|
|
Post by Wild Bill on Aug 24, 2021 22:13:16 GMT
Great review and test David. I'll stick to my faithful Econ 2's though. And my JSB Exacts for my air rifles.
|
|
|
Post by flatrajectory on Oct 30, 2021 20:15:25 GMT
I have a HW 30 s in .22, and I use H&N FTT GREEN pellets weighing 9.5 grains ( approx ), so lighter than the .177 JSB Heavies I use for hft at 10.34 grains. These alloy pellets are the most accurate and give the most m.e. in this rifle. Also they are 80 fps faster than a standard 14 grain lead pellet. Yes they are harder than lead and over time they `might` wear the rifling down somewhat, but that is just speculation at the moment. As I only use the 30s occasionally I am happy to risk that.
Pete.
|
|